[Solved] Sequencer No Power
-
Hello everyone, I'm wondering if anyone can help, I am up to the sequencer section of my Nava build and have put all resistors caps and trimmers as per the build manual but I am only getting + 15v -15v at J15 which is correct but at J7 and ICSP and J2 also all of the IC in sequencer no power. Can you point me in the right direction to solve this problem. Many thanksLast edited by cso5 on Jul 15th, '16, 05:23, edited 1 time in total.
Ist a failure in the build guide, pls. connect the wiring with 5v line.
Hello and thanks Patrick for getting back to me,
Do you mean J10 from the I/O board to J2 in sequencer section?? Just tried it and that was it. All working fine
Many thanks once again Patrick
Do you mean J10 from the I/O board to J2 in sequencer section?? Just tried it and that was it. All working fine
Many thanks once again Patrick