e-licktronic Forum

Yes, I think I fucked up a little - slipped with my pliers and rammed them straigth down into the PCB.
Loooking at the schematics there should be 4 traces that connect IC114 and IC111, right?

Are these the connected pads for the IC's (marked as red lines in th image)? Also marked is my fuck-up Blue circle
As of now I only have continuity on 2 of the connections, and I believe that I cut two of the lines, that I now have to jump with cables.
But I just want to confirm that these infact are the connected pads for the IC's and that thes traces infact run where I rammed my pliers..

Thanks for any help
https://drive.google.com/open?id=0B-tTd ... TJNWVZXQVk

It would be nice if Elicktronic could provide pdf's of the traces on top and bottom of the board. Would make troubleshooting a little easier.

AonFluX wrote:It would be nice if Elicktronic could provide pdf's of the traces on top and bottom of the board. Would make troubleshooting a little easier.

YEP!

Bump!

Vincent - is it possible to get pdf's ore something showing the traces? @e-licktronic