IT WORKS, PERFECTLY, FIRST TIME!
Posted: Feb 9th, '16, 16:54
Hi everyone,
My Yocto is complete, bar a case. It's working, first time with no (2 v small) issues.
I'd just like to thank everyone who has helped along the way, given advice etc!!
Regarding TM3, I didn't see much about calibration however for those who don't know, when you start up your Yocto, play a clap sequence and twist the trimmer until it sounds how you like, really couldn't be simpler.
The unit its self sounds incredible, especially when I overdrive the volumes slightly.
The only two issues someone may be able to assist with are as follows:
1. If I play a sequence, any sequence with all volume pots turned right the way down, these is a quiet clicking sound that seems to be triggered by the rim shot sequence.
2. The middle tom/middle conga makes a slight humming sound when the switch is in midconga position, this is amplified if I touch the switches metal casing?
Any ideas, please let me know.
Anyway, thank you all so much, it's been a pleasure.
If you have any questions please ask here/other threads/pm and i'll try my best to help but remember i'm no expert.
I'll say I did take my time to make sure there were no solder bridges, the polarities were all correct and that everything went into their respective places.
The forum is a treasure trove so dig deep!
Jeremy.
My Yocto is complete, bar a case. It's working, first time with no (2 v small) issues.
I'd just like to thank everyone who has helped along the way, given advice etc!!
Regarding TM3, I didn't see much about calibration however for those who don't know, when you start up your Yocto, play a clap sequence and twist the trimmer until it sounds how you like, really couldn't be simpler.
The unit its self sounds incredible, especially when I overdrive the volumes slightly.
The only two issues someone may be able to assist with are as follows:
1. If I play a sequence, any sequence with all volume pots turned right the way down, these is a quiet clicking sound that seems to be triggered by the rim shot sequence.
2. The middle tom/middle conga makes a slight humming sound when the switch is in midconga position, this is amplified if I touch the switches metal casing?
Any ideas, please let me know.
Anyway, thank you all so much, it's been a pleasure.
If you have any questions please ask here/other threads/pm and i'll try my best to help but remember i'm no expert.
I'll say I did take my time to make sure there were no solder bridges, the polarities were all correct and that everything went into their respective places.
The forum is a treasure trove so dig deep!
Jeremy.