e-licktronic Forum

Hello,

I've finished building my yocto, and it works pretty well until i've tried to add a power switch on it (i'm using the ericasynths metal enclosure).
I've soldered the ground cable to it (ground main board -> switch -> ground power board), but it does not seems to be an optimal solution..
On power on, the yocto behaves strangely...so i've just removed the switch.

Now, no sound comes from any output of the machine (i guess i've fried some stuff). The sequencer parts seems OK.

Could you please share with me the first test i should do to start to diagnosie/debug the problem ?
(Measuring Voltage on each building blocks as i did during the building process ?)

Thanks so much!

Alain

Ouch...

Check that you have +15V and -15V. It might be you just fried one of the regulators.

Hey halides!

Thanks for your advice!
I've just realize that the +15V/-15V contacts have been disconnected from the power board.

I've soldered some new cable on it and everything is working fine!

Thanks for the help!!

Haha, awesome!